Once the slip dries the loops will be anchored into the dried plaster and keep the two pieces from pulling apart. PLASTERCRAFT Statues, Busts, Figurines, Columns, Pedestals and Plaster Plaques David Statues and Busts Composer Busts - Beethoven, Mozart, Verdi and more. Remember to form the wire into a loop at both of its ends. If it's a lot smaller then instead of the screw you could use a piece of aluminum wire to act as the screw. I'm not sure how big of a piece we are talking about in your case. Once the pieces are together you can use a damp cloth to wipe the excess slip from the surface. If you don't them you did not use enough. You want to see the slip squeezing out of the joint. The part that is sticking out will what will hold the other part of your cast.Īlign and bring together both halves of the broken cast. Insert the screw into the pocket such that half the length of the screw is sticking out the top of the cast. We will call that length "d".ĭrill a pockets slightly larger than the head of the screw into both halves of the plaster cast to a depth of 1/2 d.įill both drilled pockets with your slip compound. Here's a quick sketch of the steps I would take.įind a narrow headed screw (such as a flooring screw) and measure its length. If you do go the tape route, use a good quality painters tape as you can leave it for hours, or days, and not worry about it leaving any residue behind. Capitol Dome Statue of Freedom is a classical female figure with long, flowing hair wearing a helmet with a crest composed of an eagles head and feathers. Hard part will be holding the two pieces together while the slip dries.ĭon't use masking tape! Masking tape will stain your material. If you don't see the slip being squeezed from the joint then you didn't use enough.īy using the same material to bind the pieces together as what the sculpture was made from you won't have to worry as much about discolouration. Just wipe off the excess with a damp cloth. When the two halves are brought together you want to see the slip forced out of the joint. Scoring the inner surface slightly giving the slip a bit of a roughened surface to bind to.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |